INSTALLATION OF SWITCH PANEL
• Install the switch panel on the dashboard at a position easy to operate at the operator’s seat. Avoid a place to be exposed to water splash.
• Before installing or removing electric parts, turn the main switch OFF and disconnect the battery cable from the battery. When disconnecting the battery cable, remove the negative cable first and then the positive cable. When connecting the cable, connect the positive cable first and then the negative cable.
Install the emergency stop switch panel and main switch panel at an appropriate position on the dashboard. Installing dimensions are as shown in the figure below.
MAIN SWITCH PANEL ASSEMBLY
INSTALLING HOLE DIMENSIONS:
Make two (2) holes of 52 mm in diameter on the main switch panel assembly as shown in the figure below. Distance between centers of two (2) holes is 37 mm.
Fix the panel with four (4) screws.
