Nuestros almacenes están cerrados los días 26 y 27 de noviembre. ¡Feliz Día de Acción de Gracias!

De confianza desde 2005★★★★★ 4.7/5 estrellas

Los pedidos de PartsPak.com serán procesados y enviados por Crowley Outdoors. Para soporte, llame al (800) 580-0720.

Owner's Manual DF200A Operation[Operation In Shallow Water]

Owner's Manual DF200A Operation[Operation In Shallow Water]
Suzuki Marine

OPERATION IN SHALLOW WATER

When operating your boat in shallow water, it may be necessary to tilt the motor higher than the normal trim angle. When you tilt the motor beyond the normal trim angle, however, you should only operate the boat at slow speeds. After returning to deep water, be sure to lower the motor to the normal trim angle.

To tilt the motor higher than the normal trim angle, use the Power Trim and Tilt switch.

When the motor is beyond the maximum trim position, the swivel bracket will not have side support from the clamp bracket and the tilt system will be unable to cushion the engine if the lower unit strikes an obstruction. This could lead to occupant injury. In addition, beyond the maximum trim position, the water intake holes may be above the water line, which can result in severe engine damage from overheating.
Do not operate the engine above 1500 r/min or operate the boat in a planning attitude with the engine beyond the maximum trim position.

If the motor hits bottom, serious damage can occur.
Do not allow the motor to hit bottom. If the motor does strike bottom, inspect it immediately for damage.

OPERATING THE TROLL MODE (Optional Item)

(Optional Item)
Trolling speed can be controlled to install the optional Troll Mode switch.

Please contact your authorized Suzuki Marine Dealer for more information.

To monitor engine speed correctly during the troll mode operation, Suzuki recommends the use of the Suzuki 2-scale Monitor Tachometer.

System Outline
The “Troll Mode System” is activated by pressing the troll mode switch, when the motor is running at in-gear idle speed. By using this system, you can set and maintain a desired engine speed with the control switch in a range from in-gear idle speed (approx. 650 r/min) to 1200 r/min).

How to use the Troll Mode
Setting the troll mode:

  1. Shift into forward or reverse gear and make sure that the throttle is fully closed (in-gear idle speed).

  2. Press the “UP” or “DN” position of the troll mode switch, until you hear one beep.

    The REV/TRL (or REV) lamp on the monitor gauge will flash indicating that the motor has been set to the troll mode. The REV/TRL (or REV) lamp will continue to flash while the motor is in the troll mode.