OPERATION IN SHALLOW WATER
When operating your boat in shallow water, it may be necessary to tilt the motor higher than the normal trim angle. When you tilt the motor beyond the normal trim angle, however, you should only operate the boat at slow speeds. After returning to deep water, be sure to lower the motor to the normal trim angle.
To tilt the motor higher than the normal trim angle, use the Power Trim and Tilt switch.
When the motor is beyond the maximum trim position, the swivel bracket will not have side support from the clamp bracket and the tilt system will be unable to cushion the engine if the lower unit strikes an obstruction. This could lead to occupant injury. In addition, beyond the maximum trim position, the water intake holes may be above the water line, which can result in severe engine damage from overheating.
Do not operate the engine above 1500 r/min or operate the boat in a planning attitude with the engine beyond the maximum trim position.
If the motor hits bottom, serious damage can occur.
Do not allow the motor to hit bottom. If the motor does strike bottom, inspect it immediately for damage.
OPERATING THE TROLL MODE (Optional Item)
Trolling speed can be controlled to install the optional Troll Mode switch.
Please contact your authorized Suzuki Marine Dealer for more information
To monitor engine speed correctly during the troll mode operation, Suzuki recommends the use of the Suzuki 2-scale Monitor Tachometer.

System Outline
The “Troll Mode System” is activated by pressing the troll mode switch, when the motor is running at in-gear idle speed. By using this system, you can set and maintain a desired engine speed with the control switch in a range from in-gear idle speed (approx. 650 r/min) to 1200 r/min).
How to use the Troll Mode
Setting the troll mode
Shift into forward or reverse gear and make sure that the throttle is fully closed (in-gear idle speed).
Press the “UP” or “DN” position of the troll mode switch, until you hear one beep.
The REV/TRL (or REV) lamp on the monitor gauge will flash indicating that the motor has been set to the troll mode. The REV/TRL (or REV) lamp will continue to flash while the motor is in the troll mode.

The troll mode system will not operate if the switch is depressed when the remote control lever is in the neutral position.
Adjusting trolling speed:
- When pressing the “UP” switch, one short beep sounds and the engine speed increases by 50 r/min.
- When pressing the “DN” switch, one short beep sounds and the engine speed decreases by 50 r/min.
• When pressing the “DN” switch at the lower limit of trolling speed, the engine speed will not change and three long (0.8 sec.) beeps will sound.
• When pressing the “UP” switch at the upper limit of trolling speed, the engine speed will not change and three long (0.8 sec.) beeps will sound.
• Shift operation and throttle control remain operational, even in troll mode.
Cancelling the troll mode:
The troll mode can be cancelled by shifting the remote control lever to the neutral position, or by increasing the engine speed to 3000 r/min or more. In both cases, two short (0.1 sec.) beeps sound when cancelling the troll mode.
OPERATION IN SALT WATER
OPERATION IN FREEZING WEATHER
When operating your outboard motor in freezing temperatures, you should keep the lower unit submerged in the water at all times.
When taking motor out of the water, stand it up in a vertical position until the cooling system drains completely.
If you leave your outboard motor out of the water in freezing temperatures with water still in the cooling system, the water can freeze and expand, causing severe damage to the motor.
When your outboard is in the water in freezing temperatures, keep the lower unit submerged in the water at all times. When the motor is stored out of the water in freezing temperatures stand it up in the vertical position so that the cooling system drains completely.
