GEAR OIL
To check the gear oil level, adjust the engine to an upright position, remove the gear oil level plug 2 and look into the hole. The oil level should be at the bottom edge of the hole. If the oil level is low, add the specified gear oil until the level reaches the bottom edge of the hole. Then, reinstall and tighten the plug.

Periodic gear oil replacement is essential for long life of your outboard motor. To change the gear oil:
Make sure the motor is in an upright position. Place a drain pan under the lower casing.
Remove the gear oil drain plug 1, then remove the gear oil level plug 2.

After the oil has drained completely, inject the specified gear oil into the lower drain hole until it just starts to come out of the upper level hole. Approximately 1100 ml (37.2/38.7 US/lmp oz.) will be required.
Reinstall and tighten the gear oil level plug (2), then quickly reinstall and tighten the gear oil drain plug (1).
To avoid insufficient injection of gear oil, check the gear oil level 10 minutes after following the procedure in the step 4. If the oil level is low, slowly inject gear oil into the gear oil level hole up to the correct level.
Gear oil can cause injury to people or pets. Repeated, prolonged contact with used gear oil may cause skin cancer. Even brief contact with used oil may irritate skin.
• Keep new and used oil away from children and pets.
• Wear a long-sleeve shirt and waterproof gloves when handling oil.
• Wash with soap if oil contacts your skin.
• Launder any clothing or rags that are wet with oil.
Recycle or properly dispose of used gear oil. Do not throw it in the trash, or pour it on the ground, down a drain, or into the water.
If fishing line wraps around the rotating propeller shaft, the propeller shaft oil seal can become damaged and can allow water to enter the gear case causing severe damage.
If the gear oil has a milky color, it is contaminated with water. Immediately contact your authorized Suzuki marine dealer for advice. Do not operate your outboard until the oil is changed and the cause of the contamination is corrected.
