Our warehouses are closed on November 26th and 27th. Happy Thanksgiving!

Trusted Since 2005★★★★★ 4.7/5 Stars

PartsPak.com orders will be processed and fulfilled by Crowley Outdoors. For support please call (800) 580-0720.

Owner's Manual DF200A Motor Removal And Transporting

Owner's Manual DF200A Motor Removal And Transporting
Suzuki Marine

Step 1: MOTOR REMOVAL

If it is necessary to remove the outboard motor from your boat, we recommend that you ask your authorized Suzuki Marine Dealer to do the work for you.

Step 2: MOTOR TRANSPORTING

When transporting the motor, place the motor either vertically or horizontally.

Vertical transport:
Attach the motor to the carrier by securing clamp bracket with two sets of transom bolt and nut.

Never use display stand for transportation of the motor.

Horizontal transport:

  1. Drain the engine oil. Refer to the ENGINE OIL section.
  2. Drain the gasoline from the vapor separator as follows:

(1) Remove the motor cover.
(2) Loosen the vapor separator drain screw (1) and drain the gasoline into a suitable container.

Gasoline is extremely flammable and toxic. It can cause a fire and can be hazardous to people and pets.
Use a proper, safe container to store any gasoline drained from the outboard motor. Keep gasoline away from sparks, flames, people, and pets.

(3) After draining, retighten the drain screw.

  1. Rest the motor on a case protector with the port side downwards as shown.

Spilled fuel or fuel vapor can cause a fire and is hazardous to health.
Always take the following precautions:
• Drain the fuel from the fuel line and fuel vapor separator before transporting the boat/outboard motor and before removing the motor from the boat.
• DO NOT lay motor on its side without draining fuel.
• Keep the motor away from open flames or sparks.
• Wipe up spilled fuel immediately.

If you are not careful when resting the outboard on its side and do not take proper precautions such as first draining the engine oil and cooling water completely, damage can occur. Engine oil may enter the cylinder from the sump, water may enter the cylinder through the exhaust port, or the outer casings may be damaged.
Always drain the engine oil and cooling water completely before laying the motor on its side, and be careful laying the motor down.

If you let the lower unit of your outboard sit higher than the power head during transporting or storing, water may trickle into the power head, causing damage to the engine.
Never let the lower unit sit higher than the power head when transporting or storing your outboard.

When horizontal transportation is performed, the matte finish paint may be damaged. For matte finish paint models, no horizontal transportation is recommended.