Our warehouses are closed on November 26th and 27th. Happy Thanksgiving!

Trusted Since 2005★★★★★ 4.7/5 Stars

PartsPak.com orders will be processed and fulfilled by Crowley Outdoors. For support please call (800) 580-0720.

Owner's Manual DF200A Diagnostic System

Owner's Manual DF200A Diagnostic System
Suzuki Marine

Step 1: KEYLESS CONTROL UNIT CAUTION SYSTEM

This system is activated when the 12 volt battery voltage to the keyless control unit drops to a point which could impair the keyless control unit performance.

If this system activates, the red CHECK ENGINE lamp will flash.

• If this system activates, check the following:
– The 12 volt battery is in sound condition.
– Contact failure of the battery terminal.
• If this caution system activates continuously, consult your authorized Suzuki Maine Dealer.

Step 2: DIAGNOSTIC SYSTEM

If abnormal conditions exist in any sensor signal being sent to the control unit, the self-diagnostic system warns of the abnormal condition.

If this system activates, the red CHECK ENGINE lamp will flash and a buzzer will sound.

Also incorporated is a fail-safe provision that allows the operation at a restricted speed even under such a failure condition.

If equipped with Keyless Start System:
• The CHECK ENGINE lamp will light briefly when the Keyless Start System is in ON state.
• The failed system can be identified by the mode of the red CHECK ENGINE lamp flashing and buzzer sounding.
The buzzer sounds for 60 seconds when the Diagnostic System is activated, then it stops automatically.
• This diagnostic code is designed to appear while the Keyless Start System is in ON state.

If not equipped with Keyless Start System:
• The CHECK ENGINE lamp will light briefly when the ignition key is turned to the “ON” position.
• The failed system can be identified by the mode of the red CHECK ENGINE lamp flashing and buzzer sounding.
This diagnostic code is designed to appear while the ignition key is turned on.
• The buzzer sound with diagnostic system activating will be canceled by pushing the ignition key in.

If the diagnostic system activates while you are operating your outboard motor, there is an abnormal condition in one of the sensor signals of the control system.
Consult your authorized Suzuki marine dealer for repair of the control system.

Step 3: OIL CHANGE REMINDER SYSTEM

This system informs the operator of the time for replacing engine oil on the basis of the maintenance schedule.

The system is designed to register the total operating hours of the outboard motor and function its operation when the preprogrammed hours have reached.

(Refer to the INSPECTION AND MAINTENANCE section and the last page.)

SYSTEM ACTIVATION
When the total operating hours have reached the preprogrammed hours, the OIL lamp will flash. If the engine is not running, the buzzer will begin a series of double beeps additionally. This indication will repeat until you cancel the system activation.

CANCELLATION

If equipped with Keyless Start System in case of Dual Engine:
• Cancellation of system activation may be achieved by operating either one of the main switch.
• In case system activation cancellation is performed on the Twin Switch Panel, the operating time of the two outboard motors will be reset simultaneously.

  1. If equipped with Keyless Start System:

    Turn the Keyless Start System to ON state by turn the main switch to the “ON & OFF” (“ ”) position and then release it. The main switch automatically returns to the “PUSH START/STOP” position.

When the Keyless Start System is ON state and the engine inactivated, buzzer continues sounding.